Design of DC-DC buck-boost non-inverting converter using PIC microcontroller
Switching MOSFET of DC-DC converters were widely used in different types of portable and non-portable electronic devices. The main aim of this research is the input voltage, which comes from a varaible sources. It is required to control model of Buck- Boost non-inverting converter controller by a...
Saved in:
| 主要作者: | |
|---|---|
| 格式: | Thesis |
| 語言: | English |
| 主題: | |
| 在線閱讀: | http://dspace.unimap.edu.my:80/xmlui/bitstream/123456789/59419/1/Page%201-24.pdf http://dspace.unimap.edu.my:80/xmlui/bitstream/123456789/59419/2/Full%20text.pdf |
| 標簽: |
添加標簽
沒有標簽, 成為第一個標記此記錄!
|
| 總結: | Switching MOSFET of DC-DC converters were widely used in different types of
portable and non-portable electronic devices. The main aim of this research is the input
voltage, which comes from a varaible sources. It is required to control model of Buck-
Boost non-inverting converter controller by a duty cycle of PWM signal. The objective
of the research is to design, simulate and analyze circuit converter to regulate the output
voltage by using PIC Microcontroller (16F877A). In the circuit design, the polarity of the
output voltage should be not changed. Moreover, the circuit is required to act
automatically from one mode to the other mode of Buck-Boost converter.
Conventionally, two converters combined together were utilized, a Buck and Boost
family of converters. The circuit were perform the dual operations of step-down and stepup
modes, which relies on input conditions. The simulation software and the
implementation hardware were completed. Proteus Software has been adopted as a
simulation tool. The PIC Microcontroller was used in this circuit to generate PWM. The
circuit was achieved the output voltage at 12VDC even the input voltage a variable with
a range of input voltages was between (6-18) VDC. This circuit was selected in this
dissertation project because it has the best specifications such as single inductor and
capacitor for both of converters, less number of electrical components, lower stresses,
which leads to reduce the total losses, cost and increase the efficiency of the circuit.
Moreover, it was achieved supply output voltage with positive polarity. From the
collected data, the average efficiency of the proposed converter was reached at 82%. A
new alternative for improving the performance of Buck-Boost non-inverting converter on
simulation for high power application was proposed with respect to conventional DC-DC
converter, current was divided by parallel modality in Multi-Modular converters.
Therefore, the high current stress on the semiconductor switches were overcame. It was
an optimal solution for high load current requirements in a DC converter. |
|---|