Combination of perturb and observe with online sequential extreme learning machine for photovoltaic system maximum power point tracking
Photovoltaic energy is one of the most renowned sources of renewable energy. Its major drawback, however, is the low efficiency of ultra-violet to electrical energy conversion. Irradiance and temperature are the major factors that determine its ability to achieve maximum power output. Maximum...
محفوظ في:
| المؤلف الرئيسي: | |
|---|---|
| التنسيق: | أطروحة |
| اللغة: | English |
| منشور في: |
2018
|
| الموضوعات: | |
| الوصول للمادة أونلاين: | http://psasir.upm.edu.my/id/eprint/75444/1/FK%202018%20123%20-%20IR.pdf |
| الوسوم: |
إضافة وسم
لا توجد وسوم, كن أول من يضع وسما على هذه التسجيلة!
|
| الملخص: | Photovoltaic energy is one of the most renowned sources of renewable energy. Its
major drawback, however, is the low efficiency of ultra-violet to electrical energy
conversion. Irradiance and temperature are the major factors that determine its
ability to achieve maximum power output. Maximum power point tracking (MPPT)
is developed in photovoltaic systems to maintain the maximum power output
produced by its source. A boost DC-DC converter with maximum power point
tracking algorithm aids in operating at the desired voltage level. From different
MPPT techniques previously proposed, the online sequential extreme learning
machine algorithm and conventional perturb and observe are combined together as a
proposed MPPT algorithm. This combination is capable of extracting energy at the
maximum operating level of a photovoltaic module.
The simulation work covers modelling of the photovoltaic module, and the boost
DC-DC converter and power LED light as a load, with maximum power point
tracking algorithm to form a photovoltaic system. This system was evaluated under
the actual environmental data based on location and dynamic MPPT efficiency tests.
For comparison purpose, the conventional extreme learning machine and modified
P&O were modelled as well.
Several factors will be triggered on the solar module performance, and the PV
module will be degraded over time. In this thesis, the proposed method will be
emulated under the degradation of maximum output PV current. The diode ideality
factor was chosen to evaluate the PV output current degradation.System elements are individually modelled in MATLAB/M-File and then connected
to assess performance under different environmental conditions. The simulated
results of the complete PV system show that the performances of the PV module
using the proposed MPPT technique provide better output power when compared
with the conventional ELM and modified P&O. It yields not only a reduction in
convergence time to track the maximum power point but also significant output
power when subjected to slow and rapid solar irradiance changes. |
|---|