Buck converter switching design using microcontroller

Buck converter switching design using microcontroller

This paper presents an implementation of a PIC18F4550 microcontroller to control the operation of a buck converter. Buck converter is a DC-DC converter which will step down a higher voltage to a lower voltage level. This microcontroller is used to produce Pulse Width Modulation (PWM) signal with con...

Saved in:

書目詳細資料
主要作者:	Che Sham, Izwan
格式:	Thesis
語言:	English English English
出版:	2013
主題:	TK7800-8360 Electronics
在線閱讀:	http://eprints.uthm.edu.my/6649/1/24p%20IZWAN%20CHE%20SHAM.pdf http://eprints.uthm.edu.my/6649/2/IZWAN%20CHE%20SHAM%20COPYRIGHT%20DECLARATION.pdf http://eprints.uthm.edu.my/6649/3/IZWAN%20CHE%20SHAM%20WATERMARK.pdf
標簽:	添加標簽沒有標簽, 成為第一個標記此記錄!

相似書籍

Design zero-voltage switching DC-DC buck converter
由: Abdullah, Rohafiza
出版: (2014)

An improved perturbation and observation in MPPT control using buck-boost converter in solar panel
由: Tapri, Hidayah
出版: (2019)

Development of three phase back to back converter with current flow control using raspberry Pi microcontroller
由: Mamat, Ibrahim
出版: (2015)

Voltage tracking of a DC-DC buck converter using neural network control
由: Mohamad Narsardin, Mohamad Adhar
出版: (2012)

Development of a DC-DC buck boost converter using fuzzy logic control
由: Shaban Jaber, Fathi
出版: (2011)

Development of a non-pulsating buck-boost converter with continuous current mode (CCM)
由: Zakaria, Mohd Sharif
出版: (2013)

Multilevel capacitor-clamped DC-DC boost converter structure with soft-switching technique implementation for high power density achievement
由: Kasiran, Mohd Amirul Naim
出版: (2019)

Voltage tracking of a DC-DC buck-boost converter using gaussian fuzzy logic control
由: Omar, Gadaffi
出版: (2012)

Design on switching sequence for control circuit by using Altera Max+Plus II
由: Aziz, Roziah
出版: (2007)

Design and analysis DC/DC boost converter using pi controller for battery charger application
由: Yasin, Abdullahi Jamal
出版: (2020)

Development Of Microcontroller Controlled Computer Numerical Control (Cnc) Router Machine With Graphical User Interface (Gui)
由: Yaziz, Mohd Farizul Hazimi Mohd
出版: (2016)

PV boost converter conditioning using neural network
由: Abd Aziz, Aizat
出版: (2013)

A Study And Development Of Digital Control Technique For Power Factor Correction Using Pre-Calculated Algorithm With A Low Cost 8-Bit Microcontroller
由: Liau , Wei Chun
出版: (2013)

Design Of Multiply-By-Two Amplifier For 1.5 Bit Pipelined Analogue-To-Digital Converter Application
由: Teng , Jin Chung
出版: (2014)

Design of dual-input two phase dc/dc converter with modified pulse width modulation (mpwm)
由: Abu Bakar, Afarulrazi
出版: (2019)

Development of DC-DC converter for DC motor using neural network controller
由: Abdullah, Rasyidi
出版: (2013)

Development of back-to-back converter with power transfer control using raspberry Pi
由: Ahmad Shah, Shahrizan
出版: (2015)

High Speed Nyquist Analog To Digital Converter In CMOS
由: Seemi, Shazia
出版: (2006)

Torque Ripple Minimization In Switched Reluctance Motors Using Novel Fuzzy Logic Based Techniques
由: Ramasamy, Gobbi
出版: (2008)

Design And Development Of Unipolar SPWM Switching Pulses For Single Phase Full Bridge Inverter Application [TK7871.85. B151 2008 f rb].
由: Ismail, Baharuddin
出版: (2008)

8 Bit Cmos Hybrid Digital-To-Analog Converter For Bluetooth Low Energy Application
由: Rosli, Alia
出版: (2019)

Verification Of Non-Isolated Lcc Resonant Full Bridge Dc-Dc Converter For Solar Photovoltaic Systems
由: Teoh , Voon Min
出版: (2015)

Design Of A Single Phase Unity Power Factor Switch Mode Power Supply (SMPS) With Active Power Factor Correction [TK7881.15. N335 2008 f rb].
由: Abdullah, Mohamad Nazir
出版: (2008)

Finite Impulse Response Filter Design Using VHDL
由: Ong, Poay Yin
出版: (2003)

Design multilayer bandpass filter using hairpin resonator for digital broadcasting
由: Abdullah, Qazwan
出版: (2015)

Design, modeling and implementation of antennas using electromagnetic bandgap material and defected ground planes
由: Zainal Abidin, Zuhairah
出版: (2011)

Design of 32-Bit Arithmetic Logic Unit Using Shannon Theorem Based Adder Approach
由: C., Senthilpari
出版: (2009)

Analysis of Partial Binary Tree Network (Pbtn) For Dynamic Element Matching (Dem) Digital To Analog Converter (Dac)_
由: Lim , Ee Wey
出版: (2016)

Design Rule Check To Validate Option Metal And Via For A Preprogrammed Layout Design
由: Oothayer Kumar, Sureindra Kumar
出版: (2014)

Modelling of thermal and charge/discharge cycle behaviors of nickel metal hydride (NI-MH) battery system
由: Mohammad Firdaus, Abu Hashim
出版: (2013)

Design rectenna for wireless energy harvesting
由: Elmi Gure, Abdirahman
出版: (2015)

Design of zero-current switching DC-DC buck converter
由: Muhamad, Nor Azrinna
出版: (2014)

Design on switching sequence for control circuit by using altera MAX+PLUS II
由: Aziz, Roziah
出版: (2007)

Design And Simulation Of Cmos-Based Low Voltage Variation Bandgap Reference Voltage Circuitry Using 0.18μm Process Technology
由: Tan, Chee Yong
出版: (2015)

New Cdc Design Tool For Analog Layout Workflow
由: Ng , Hin Mung
出版: (2015)

Design of microstrip antenna based on different material properties
由: Ibrahim, Anis Nabihah
出版: (2015)

A computational tool for microstrip planar filter design
由: Mahgoub Elsayed, Mazen Hashim
出版: (2017)

Design and characterisation of wideband antennas for microwave imaging applications
由: Yahya @ Atan, Roshayati
出版: (2016)

Design of Ultra-Wideband Antenna With Bandpass Filtering Capability
由: Qasem Ahmed, Sharif Ahmed
出版: (2020)

Design And Development Of L-Band Slotted Waveguide Antenna
由: Lim, Ka Sing
出版: (2004)

Services hosted by the Perpustakaan Sultan Abdul Samad, Universiti Putra Malaysia with Cooperation MySyL Group