Ball and beam control system design using microcontroller

Ball and beam control system design using microcontroller

This project report will present a ball and beam system design using microcontroller. The system consists of two parts. The first part is hardware module and the second part is software module. Hardware module is interfaced with the software module. The ball and beam system is the most popular labor...

Saved in:

書目詳細資料
主要作者:	Zainal, Sheikh Muhammad Hafiz Fahami
格式:	Thesis
語言:	English
出版:	2009
主題:	TK Electrical engineering Electronics Nuclear engineering
在線閱讀:	http://eprints.utm.my/id/eprint/12028/6/SheikhMuhammadHafizMFKE2009.pdf
標簽:	添加標簽沒有標簽, 成為第一個標記此記錄!

相似書籍

Ball and beam balancer control using microcontroller
由: Ismail, Nadiah
出版: (2009)

Modeling and controller design of a ball and beam balancer system
由: Khalifa, Mustafa Saad
出版: (2009)

Position control using fuzzy-based controller for pneumatic-servo cylinder in ball and beam application
由: Azman, Muhammad Asyraf
出版: (2014)

Control of cart-ball system using state feedback and fuzzy logic controller
由: Basir, Budiman Azzali
出版: (2007)

Distributed microcontroller system using canbus
由: Mahadzir, Nazmy
出版: (2009)

Modeling and control of dual motor Ball & Bean system
由: Hao, Peng Yu
出版: (2012)

Distributed 68HC11 microcontroller using SJA 1000AS controller area network
由: Rahmat, Normala
出版: (2009)

Microcontroller-based human stress detection system using fuzzy logic
由: Airij, Awais Gul
出版: (2015)

Intelligent robot arm using AVR microcontroller / Nuzaimah Hanifah
由: Hanifah, Nuzaimah
出版: (2007)

Control of a magentically suspended balance beam system by using integral slidung mode control
由: Abdollah @ Buyong, Rafidah
出版: (2007)

Non-intrusive load management system for residential loads using artificial neural network based arduino microcontroller
由: Abubakar, Isiyaku
出版: (2018)

MEMS Resonator Q-factor microcontroller based measurement system / Ahmad Afdhaluddin Mohammad Aris
由: Mohammad Aris, Ahmad Afdhaluddin
出版: (2013)

An efficient microcontroller-based electronic ballast for high pressure sodium lamps used in street lighting
由: Omar, Mohd. Hamizan
出版: (2013)

Design Of A Microcontroller-Based Converter For 3-Phase Brushless DC Motor Drives
由: Mohd Nayan, Norkharziana
出版: (2009)

Modeling and controller design for heating and ventilation control system using system identification approach
由: Mohd. Subha, Nurul Adilla
出版: (2009)

Modeling and controller design for a cruise control system
由: Osman, Khairuddin
出版: (2008)

Expert system in control systems analysis and design
由: Baba, Rosmawati
出版: (1992)

Trajectory Analysis Of Ball Based On Image Processing And Simulation
由: Anthony Louis, Stephanie
出版: (2017)

Optimal design for multiple mode charging station with PI controller using particle swarm optimization
由: Shafad, Khairul Hafiz
出版: (2017)

Controller design of hydraulic actuator system using self-tuning and model reference adaptive control
由: Salleh, Sazilah
出版: (2015)

Observer design for active suspension system using sliding mode control
由: Akbari, Elnaz
出版: (2010)

Modeling and controller design of an inverted pendulum system using AI approach
由: Najafzadeh, Nazila
出版: (2012)

Modelling and simulation of magnetically suspended balance beam system
由: Fauzi, Fijay
出版: (2006)

Design of reduced-size multilayer coupler for butler matrix beam forming network
由: Ausordin, Siti Fatimah
出版: (2013)

Error handling and controller design for controller area network-based networked control system
由: Nor Shah, Mohd. Badril
出版: (2015)

Modeling and controller design for an inverted pendulum system
由: Nasir, Ahmad Nor Kasruddin
出版: (2007)

Dual beam width beamforming network for smart antenna system
由: Ibrahim Ulusow, Abdurahman Mohamed
出版: (2010)

Application of virtual instrumentation in position control system using direct digital control via PID and fuzzy logic controller
由: Md. Ghazaly, Mariam
出版: (2005)

Electron beam sterilization
由: Nor Rul Hasma, Abdullah
出版: (2004)

Robust PID controller design for nonlinear system using Linear Matrix Inequality (LMI)
由: Hassan, Nurhaffizah
出版: (2010)

Modeling and design control strategy for unwind/rewind system
由: Ismail, Muhamad Fahezal
出版: (2008)

Modeling and controller design of permanent magnet synchronizing motor (PMSM)
由: Zainal, Noran Zahrine
出版: (2013)

Miniaturized planar capacitance tomography system using fan beam projection technique for stagnant samples visualization
由: Azmi, Aizat
出版: (2015)

Fan beam optical tomography
由: Tajjudin, Mazidah
出版: (2005)

Modelling and controller design for position tracking of pneumatic actuator system
由: Khong, Fan Hao
出版: (2022)

State and parameter estimator design for control of vehicle suspension system
由: Sandhu, Fargham
出版: (2017)

Design and implementation of predictive control for networked multi-process systems
由: Mohd. Subha, Nurul Adilla
出版: (2016)

Modeling and controller design of a hot air blower system
由: Wan Salihin Wong, Khairul Nizar Syazwan
出版: (2014)

Simulation and design of road vehicle following system with adaptive gain controller
由: Mohamad Sapiee, Mohd. Razali
出版: (2009)

Two dimensional switched beam antenna at 28 GHz for fifth generation wireless system
由: Orakwue, Stella Ifeoma
出版: (2016)

Services hosted by the Perpustakaan Sultan Abdul Samad, Universiti Putra Malaysia with Cooperation MySyL Group