The effects of the electroless copper coating to the thermal expansion behaviors of silicon carbide particles reinforced copper matrix composites for the electronic packaging applications
The demands for advanced thermal management materials with high thermal conductivity and low coefficient of thermal expansion (CTE) are expected to increase due to the technological progress in the thermal management hardware. Silicon carbide reinforced copper matrix (Cu-SiCp) composites are high...
Saved in:
| Summary: | The demands for advanced thermal management materials with high thermal
conductivity and low coefficient of thermal expansion (CTE) are expected to increase
due to the technological progress in the thermal management hardware. Silicon carbide
reinforced copper matrix (Cu-SiCp) composites are highly rated as thermal management materials due to the high thermal conductivity and low CTE properties. But the Cu-SiCp composites fabricated via the conventional powder metallurgy methods have inferior thermophysical properties due to the absence of bonding between the copper matrix and the SiCp reinforcement. In order to improve the bonding between the two constituents,
the SiCp were copper coated via electroless coating process. The electroless plating
process consisted of surface cleaning, sensitization, activation and copper deposition
processes. In between the processes, the ceramic particles were rinsed thoroughly with
deionized water to minimize contamination. Based on the experimental results and
findings, a continuous copper deposition on the SiCp was obtained via the electroless
plating process. The copper film was found to be high in purity and homogeneously
deposited on the SiCp surfaces. The thickness of the coated copper layer was roughly
estimated to be less than 1mm. The copper coated layer on the SiCp also improved the
bonding between the copper matrix and SiCp reinforcement. The copper coated layer
improved the green strength of the composites thus allowed a high volume fraction of
SiCp to be incorporated into the copper matrix. The CTE values of the copper coated
Cu-SiCp composites were significantly lower than those of the uncoated Cu-SiCp
composites. The CTE of the coated Cu-SiCp composites were in agreement with
Kernel’s model. The microstructure examination of the composites also supports the
CTE results. A good bonding between the copper matrix and the SiCp reinforcement
exists in the copper coated Cu-SiCp composites. Where else in the non-coated Cu-SiCp
composites, submicron gaps were observed between the copper matrix and the SiCp
reinforcement. This could be the reasons behind the higher CTE values as compared to
copper coated Cu-SiCp composites. |
|---|